USB Programmer for AVR

       USBasp - USB programmer for Atmel AVR controller's.USBasp is a USB in-circuit programmer for Atmel AVR controllers.It simply consists of an ATMega48 or an ATMega8 and a couple of passive components.The programmer uses a firmware-only USB driver, no special USB controller is needed.

Its Features are:-

Works under multiple platforms. Linux, Mac OS X and Windows are tested, No special controllers or smd components are needed, Programming speed is up to 5kBytes/sec, SCK option to support targets with low clock speed (< 1,5MHz, serial interface to target (e.g. for debugging)

In the Schematic note the following points:-

BLACK Wire is Ground .

RED Wire is Vcc 5V .

BROWN Wire is Data -.

GREEN Wire is Data +. 

Download

Firmware and circuit are available at http://www.fischl.de/usbasp/

Please refer to Readme.txt for details on building, installing and using USBasp.

Software used

1) AVRDUDE supports USBasp since version 5.2! Get AVRDUDE.

2)Khazama AVR Programmer is a Windows XP/Vista GUI application for USBasp and   avrdude.

3) eXtreme Burner - AVR is a Windows GUI Software for USBasp based USB AVR programmers.

All these Three softwares Are available at downloads...